Ask the Cisco Kid! Your one stop for all the networking help you need.

Resetting the LWAPP Configuration on a Lightweight AP

If you are using a Wireless Controller and for some reason you want to reset the AP.  There are 3 different ways to do this depending on your current set up.

Using the Controller.

1. Login in to Controller
2. Wireless
3. All Aps
4. Select Ap you want to reset
5. Click reset to Factory defaults

Using the Console.

1. Console in
2. run command:  clear lwapp private-config

Using the Reset Button.

1. Unplug the AP from Power.
2. Push and hold the "Mode" button use a pen if needed.
3. Plug in the the power.
4. Hold the "Mode" button until Status light goes from yellow to purple. About 30 seconds.
5. Release "Mode"  button