Resetting the LWAPP Configuration on a Lightweight AP
If you are using a Wireless Controller and for some reason you want to reset the AP. There are 3 different ways to do this depending on your current set up.
Using the Controller.
- Login in to Controller
- Wireless
- All Aps
- Select Ap you want to reset
- Click reset to Factory defaults
Using the Console.
- Console in
- run command: clear lwapp private-config
Using the Reset Button.
- Unplug the AP from Power.
- Push and hold the "Mode" button use a pen if needed.
- Plug in the the power.
- Hold the "Mode" button until Status light goes from yellow to purple. About 30 seconds.
- Release "Mode" button
Factory Reset Cisco Ip Phone
I- To perform a basic reset of your cisco phone (7941g and 7911) - those two are the one I am using in my lab.
type on the phone :
1- From the Settings menu, PRESS **# ( to unlock the menu)
2-PRESS more button
3-PRESS erase button
II- To perform a FACTORY RESET
Step 1 Unplug the power cable from the phone and then plug it back in.
The phone begins its power up cycle.
Step 2 While the phone is powering up, and before the Speaker button flashes on and off,
press and hold #.
Continue to hold # until each line button flashes on and off in sequence in amber.
Step 3 Release # and press 123456789*0#.
You can press a key twice in a row, but if you press the keys out of sequence, the factory reset will not take place.
After you press these keys, the line buttons on the phone flash red and the phone goes through the factory reset process.
Do not power down the phone until it completes the factory reset process and the main screen appears.
Tags
Categories
- Articles (1)
- AskTheCiscoKid.com (2)
- Demo (1)
- Firewalls (4)
- ASA (2)
- News (3)
- Nexus (3)
- 1000v (3)
- Quick Tips (3)
- Routers (4)
- Switchs (5)
- VOIP (3)
- Wireless (1)
- Controller (1)
Links
User Control
Follow Me on Twitter!
